This device provides the following communication channels:
- Ethernet port, RJ-45
- Additional Ethernet port, RJ-45 (2x)
- Optional set of 2x RS-232 and 1x RS-485 ports
This device supports the following industrial communication protocols:
- EtherNet/IP
- Modbus TCP
- Siemens S7 (S7-300/400/1200 syntax)
- Melsec Q3
- Toyopuc
- OPC UA – OPC Unified Architecture driver
- KNX
A typical network topology is pictured below:
Once the device is connected to a local area network, it can be easily accessed and configured via a web browser installed on your computer. After entering a valid IP address in your web browser you will see the configuration interface of the device. The default IP address is set to:
192.168.13.20
You need to enter the correct username and password to access the advanced system settings. Default login details are:
user name: admin
password: admin
Do not forget to change the default password after you log in to avoid any unauthorized access to your device!!
All components and settings of the configuration interface are described later in this manual.